At the risk of yankin' yer chain, Dennis, ya need ta lighten up and do like the song says, least oncet in a while: don't worry, be happy. You have taken your training seriously, that's good; but people, ya gotta take with a grain of salt... about twenty years ago I had a heated discussion with my dad, who judged me harshly and without justification. He was a control freak, so I did not stick around to argue or quarrel with him My back let me know it was not happy with sthe experience, as I had to almost lay down with the pain. Old bike injury. I wrote this poem: God is not some Bouncer at our Beck and call who Kicks out the Demons of our dis-eases He lets us Learn to walk on our own; When we fall torn, broken bruised He picks us up Sets us down Brushes off the dirt Kisses away the tears - as we allow Him - and whispers intently lovingly into our Ears: "Try again, my Child! "
Dennis, you are the best. "Illegitimi non carborundum! " - Stanley ________________________________ From: Dennis <[email protected]> To: [email protected] Sent: Thursday, September 10, 2009 5:39:23 PM Subject: [Nighthawk Lovers] Re: K&N filter saga continues. Me too. Your input here is the best thing this group's got going. And, if you don't bear fools very well, well, that's fine. It just means we all need to straighten up and pay attention. I don't know where the hell else we'd find your kind of quality of advice and experience. I know my bike's running a lot better since you helped me. Dennis G. - '85 & '86 CB700SC - Seattle -----Original Message----- >From: [email protected] >[mailto:[email protected]] On Behalf Of [email protected] >Sent: 10 September, 2009 15:33 >To: [email protected] >Subject: [Nighthawk Lovers] Re: K&N filter saga continues. > >I agree 110%. > > >On Thu, Sep 10, 2009 at 4:49 AM, Graham Rogers <[email protected]> wrote: > >What are you talking about Dennis? It takes a little back and forth (maybe a >lot back and forth) but you've opened a window to most of us who would be >otherwise groping around in the dark. I see most doing exactly what you say, >as best they can. I've learned more from you than I did in all my years up to >this point. Do you realise how many of us wish we had your skills and >experience? Don't give up on us. We are grateful beyond words, Graham >> >> >>On Sep 10, 2009, at 12:46 AM, Dennis Hammerl wrote: >> >>Idle mix screws set to around two turns out from lightly seated. It isn't >>going to help much if at all. They only have a real effect with the throttle >>closed. IE: idle or slowing. I'll mike my wires and pass along the sizes. >>>Why is it that most folks want to try something else first ? Did I waste my >>>life doing this ? Do you think I'm f%king with you ? I'm passing along just >>>the same things I'd be doing if the job was mine. I'm getting a tad tired of >>>this. It's not just you, almost everybody. >>> >>>--- On Wed, 9/9/09, Kyle Munz <[email protected]> wrote: >>> >>> >>>>From: Kyle Munz <[email protected]> >>>>Subject: [Nighthawk Lovers] Re: K&N filter saga continues. >>>>To: [email protected] >>>>Date: Wednesday, September 9, 2009, 9:20 PM >>>> >>>> >>>>I finally got back to my yogurt cup tuning. I cut it down so that the large >>>>diameter of the yogurt cup was the same as the inside small diameter of the >>>>K&N cone. Now it sits on the bottom of the cone snug against the pleats and >>>>is about 3" below the opening of the cone. This really didn't make much >>>>difference though with the lean popping behavior. Slightly worse than it >>>>was with the full size cup, not quite as bad as just the straight K&N. So, >>>>since I want the K&N to work, I guess this leaves the carbs. Before >>>>checking the jet size, I'm wondering if it would be worth it to try quarter >>>>or eighth turn adjustments to these? The PO said they were rebuilt carbs so >>>>it's possible those aren't set right, especially since the limiter caps are >>>>all removed. My buddy has the tiny carburetor drill bits for checking the >>>>jet sizes. I'll see if I can't borrow those off of him. >>>> >>>>Pictures of the trimmed cup and mp3 of both the OEM airfilter and the K&N >>>>are on my blog. http://munz.kicks-ass.net/nighthawk/?p=295 >>>> >>>>-Kyle >>>>-Sent from Houston, TX, United States >>>> >>>> >>>> >>>>On Fri, Sep 4, 2009 at 10:49 PM, Dennis Hammerl <[email protected]> wrote: >>>> >>>>That's the largest cup I've seen so far in one of those. !! Mine is about >>>>2/3 that size and truncated. Now, you have to admit it works. The remaining >>>>issue is still to be addressed. Get a small (stubby) Phillips screw driver >>>>and remove one of the outer float bowls (carbs on bike) and check the main >>>>jet size. Actually check the slow jet size too. The OEM is #115 and #35. >>>>What you are describing is happening during "transition" (from all jets as >>>>a collective to main) As the revs climb above the trouble zone and the air >>>>speed (that's what this is all about, remember?) increases enough to >>>>atomize a lot of fuel, it goes good. I'm not there and have no crystal >>>>ball, this is my best guess at this point. You have increased air speed a >>>>ton and it does run better. Now you have to dig in. Even if the jet sizes >>>>are correct, there is no reason to believe it. That's where sized wires >>>>come in. I can supply you with the the wire sizes (and wires) to check that they have / have not been reamed to some new size. your bike has been altered which you cannot deny. Does it go deeper ? Let's see. When you get it right, that gonzo cup might have to be replaced with a smaller one. From what you say, you've made great progress with your problem. The last little bit always takes the most work. You're gonna' get it right. Hang in there. >>>>> >>>>>Just a note, yogurt cups are for California models. 49 state models use >>>>>soft drink cups. >>>>> >>>>>--- On Fri, 9/4/09, Kyle Munz <[email protected]> wrote: >>>>> >>>>> >>>>>>From: Kyle Munz <[email protected]> >>>>>>Subject: [Nighthawk Lovers] K&N filter saga continues. >>>>>>To: [email protected] >>>>>>Date: Friday, September 4, 2009, 10:41 PM >>>>>> >>>>>> >>>>>> >>>>>>Ok, Per Dennis' advice I reduced the interior volume of my cone-shaped >>>>>>K&N filter, and that definitely improved things but it's not quite >>>>>>perfect. >>>>>>I couldn't locate a dixie cup (when you need one they're nowhere around) >>>>>>so I went with an empty yogurt cup. Sorry, I don't know what flavor. >>>>>>Anyhow, this took the bike from popping constantly and barely climbing >>>>>>above 4grand to a bike that will actually start, idle, and rev. >>>>>>It still is off just a tad. The exhaust sounds a bit more "hollow" that >>>>>>it did before. Can't describe it better than that. >>>>>>I've recorded an audio file of the exhaust popping and posted it on my >>>>>>blog at http://munz.kicks-ass.net/nighthawk/?p=280 for anyone interested. >>>>>>It starts at 2K, moves up the 3K, then to 4K where it starts to pop a >>>>>>bit, and then starts to pop alot as I move up to 5K. After 5K it takes >>>>>>off like a champ and definitely has more power in the higher revs than it >>>>>>did before, but I want the lower RPM rideability I hear so much about ;) >>>>>>The end of the audio file is a quick rev up to 8K with no popping, it's >>>>>>just trying to sustain it between 4 and 5 that is kind of rough. >>>>>> >>>>>>So, do I keep tweaking my yogurt cups or is it time to monkey with the >>>>>>jets? I really don't want to monkey with the jets :) >>>>>>Also, all test rides were done with the lid and snorkel bolted in place. >>>>>> >>>>>> >>>>>> >>>>>> >>>>>>-Kyle >>>>>>-Sent from Houston, TX, United States >>>>>> >>>>>> >>>>> >>>>> >>>>> >>>> >>>> >>>> >>> >>> >>> >>><photo0364#1.jpg><5Z1801E1.jpg><Four-Carbs#1.jpg> >> >> >>>> >> --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en -~----------~----~----~----~------~----~------~--~---
