airbox Y-boots $25 shipped airbox w/ snorkel and filter $45 shipped
On Aug 12, 12:19 pm, "J. Love" <[email protected]> wrote: > Also, engine and frame with title are already spoken for > > On Aug 12, 12:11 pm, "J. Love" <[email protected]> wrote: > > > I have a running 1984 Nighthawk 700 S that I am partingdue to the > > starter chain failing on me. > > > Regretfully I have a list of parts, reply to my profile email if you > > want it and I'll update the list. > > I accept paypal payments. Please allow 3-5 days for takeoff/shipping > > after payment is made. > > All prices are listed w/ shipping to continental US, but PLEASE feel > > free to make me a reasonable offer. > > Also if you notice, generally what I want is approximately half of > > what is found on Ebay. Not trying to gouge y'all! > > > Fairing and headlight w/o windscreen. Needs repair,repaint, and decals > > and missing lower mounting tabs. $75 shipped (Harbor freight sells a > > plastic welder w/ self-container air unit for $60 and evidently it is > > a miracle tool!) > > > Gas tank has minor ding in left side decal area. Decals are near > > perfect though. inside rusted tank but > > I thoroughly cleaned it w/ acid and got big flakes out then treated w/ > > WD40. Has minor pinholes. Must be sealed. Doesn't include cap, petcock > > or sending unit. $100 as is $200 if I treat it w/ POR15 polymer tank > > sealer > > > 2 sets of carburetors: > > 1 known good cleaned set ready to bolt on came from running bike, > > drained $175 shipped > > 1 needs to be cleaned set, stuck needle slides $100 shipped > > I can clean these for another $60 (a deal!) also I can rejet either > > one of these sets to your specs for $80 > > Dynojet kits are OKAY but I am using the factory needles w/ shims and > > bigger pilot jets (size 38 Keihin jet) > > > Petcock. diassembled, cleaned and vacuum diaphragm is perfect. $40 > > shipped > > > Fuel Sending unit. rusted but no big flakes, wirebrushed w/ PB blaster > > $30 shipped > > > FuelTank mounting rubbers, isolators, t-washer and bolt $20 shipped > > > Left side panel w/o petcock trim $50 shipped > > > right side battery holding bracket $20 shipped > > > Seat pan, foam, travelcade tie-on seatcover $75 shipped > > > hydraulic master cylinder w/ lines and lever $50 shipped > > > brake master cylinder w/ lines and lever $50 shipped > > > brake calipers L/R $50 EACH shipped > > > front fender and fork brace $50 shipped > > > CDI Unit $50 shipped > > > rectifier unit $50 shipped > > > Ignition Coils + wires $50 shipped > > > rear fairing + grab handle $50 shipped > > > The entire rear drive assembly (shaft+drive+ rear axle bolt) $75 > > shipped > > > Gauge assembly including speedo/tach and indicator lights $50 shipped > > > ignition switch + fuel cap+ frame lock + matching key $50 shipped > > > throttle tube and right hand switch assembly w/ pull cable ONLY $50 > > shipped > > > left hand switch assembly $20 shipped > > > Horn $10 shipped > > > rear brake drum assembly w/ shoes $35 shipped > > > rear brake light $30 shipped > > > rear fender and tag bracket $50 shipped > > turn signals/bulbs w/o stalks $35 for all 4 shipped > > > handlebars $20 shipped > > > Anything else you don't see here and you need, shoot me an email or > > call me 704-564-9949. > > > Thanks yall and hopefully I will get another 700 asap -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en.
