Thanks Allen......!

On Wednesday, September 26, 2012 9:38:01 PM UTC+10, Allen wrote:
>
> Not hard. Pull the forks, remove top cap, spring/spacer, dust cap, and 
> spring clip. Drain out the fluid, then clamp the lower tube and use the 
> upper tube to slide hammer out the seal. Reverse for installation. Note on 
> all the forks I've done the slider bushings were worn so I'd just plan on 
> replacing them. Also if you do replace the bushings, put some tape over the 
> grooves on the end of the lower tube to protect the teflon. I just cut the 
> old fork seals and used them with a drift to install the new seals.
> Sent via BlackBerry by AT&T
> ------------------------------
> *From: * Shane Townsend <[email protected] <javascript:>> 
> *Sender: * [email protected] <javascript:> 
> *Date: *Tue, 25 Sep 2012 23:15:14 -0700 (PDT)
> *To: *<[email protected] <javascript:>>
> *ReplyTo: * [email protected] <javascript:> 
> *Subject: *[Nighthawk Lovers] Replace fork oil seals and dust seals on 
> CB750SC Nighthawk S 1984
>
> Hello all....hope you are all well.......
>
> Haven't been on the site for a while....too busy in between work and my 
> other project ("basket case rebuild" Honda 87 750 Hurricane).....
>
> Please help......how difficult is it to change the front fork oil seals 
> and dust seals on my 84 CB750SC.?
>
> Do I need any specialist tools and what is the procedure....?
>
> I was quoted $250 by my local dealer is that a better option..?
>
> Shane
>
> -- 
> You received this message because you are subscribed to the Google Groups 
> "Nighthawk Motorcycle Lovers!" group.
> To post to this group, send email to [email protected]<javascript:>
> .
> To unsubscribe from this group, send email to 
> [email protected] <javascript:>.
> Visit this group at 
> http://groups.google.com/group/nighthawk_lovers?hl=en-US.
>  
>  
>

-- 
You received this message because you are subscribed to the Google Groups 
"Nighthawk Motorcycle Lovers!" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
Visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en-US.


Reply via email to