Kurt, I misunderstood the premise. I thought you were referring to the third wire on the turn signal light. If referring to the power wire for the running light, you are correct, and it would be “hot”, and must be kept insulated.
Gene From: Kurt Nolte Sent: Saturday, February 23, 2013 1:37 PM To: [email protected] Subject: Re: [Nighthawk Lovers] Gene, You say that connecting the hot-side supply wire for the running lights directly to ground should not have any ill effects? Effectively that would be creating a "short" condition, battery voltage directly to ground with only the resistance of the switch and the wires; that's a bad thing. Now, letting the third wire -on the turn signal itself- dangle free, that wouldn't cause a problem at all. Letting the supply wire from the bike dangle free, though; that's a recipe for blown fuses, at a minimum. -Kurt On Sat, Feb 23, 2013 at 2:29 PM, Hanghank <[email protected]> wrote: Kurt, I disagree. Assuming you have the correct ground/common wire on the bulb connected to ground on the bike, what you do – or don’t do – with the third wire is incidental. Fasten it to a ground if you wish, it doesn’t matter. Put a band aid on it, dip it in vodka, etc. etc.. You could even hook up both “hot” wires together, and have them on at the same time, but brighter! Gene From: Kurt Nolte Sent: Saturday, February 23, 2013 1:12 PM To: [email protected] Subject: Re: [Nighthawk Lovers] The third wire is the wire for the "always on" running lights. I've been hunting for LED 3-wire lights for quite some time, nobody seems interested in making them. As long as you have that wire end tied off somewhere that it can't come in contact with a ground, you'll be fine. Tape up the end, tie it back securely, and run with two-wire lights. -Kurt PS: There IS a way to make two-wire lights function as three-wire lights, but it involves splicing power diodes into your lines, which takes a bit of doing and some careful component selection and in most cases isn't really worth it, in my opinion. On Sat, Feb 23, 2013 at 1:52 PM, Greg Holuban <[email protected]> wrote: all the LEDs that I see only have two wires . Sent from my Verizon Wireless 4G LTE DROID Allen Thomas <[email protected]> wrote: You are trying to install rear led signals on the front. Yes a solid state relay is the best fix for blink rate. Turn signal indicator will still work as is. Sent via BlackBerry by AT&T ---------------------------------------------------------------------------- From: Greg Holuban <[email protected]> Sender: [email protected] Date: Fri, 22 Feb 2013 23:52:14 -0500 To: nighthawk_lovers<[email protected]> ReplyTo: [email protected] Subject: [Nighthawk Lovers] Could anyone help me out a little bit about changing to led turn signals? I am wondering what to do with the third wire on the front signals since the leds come with only two. Also, what is the best way to control the flashing? Can a simple led relay fix the problem, or do I need a regulator? And what about the turn signal indicator between the gauges? Thanks to anyone who can help me in advance. 91 750 -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en-US. For more options, visit https://groups.google.com/groups/opt_out.
