You're welcome dario. thanks for the torque information. I have the Honda service manual for the bike and always follow it to the letter. I replaced all four of my studs and used loctite 242 (blue) on the threads as a thread protector. I have since found out that this part number is actually listed, not for the Nighthawk S, but rather many other Hondas from that era as well as some Acura and Honda cars!!! It is however the part # my local Honda Powerhouse shop sold me. There is a very small difference in them over the originals in that the non-threaded portion of the stud is a little smaller on the new ones vrs. the originals. Be careful when turning them into the fork as they bottom out before all the thread has been used!!!
On Wednesday, June 11, 2014 12:55:23 PM UTC-2:30, Dario wrote: > > Hello Allen, > > Thank you so much for the information. I already register the part > number. I need to replace one in my 700S. > > And you don't need to use tread locker. You have a washer, pressure > washer and torque the nut between 18 - 25 N-m , or 13 - 18 ft-lb. > > Best regards, > > > On Tuesday, June 10, 2014 4:59:19 PM UTC-4, 750S wrote: > >> >> <https://lh6.googleusercontent.com/-4MkIUvGXwpc/U5dxoLxyB-I/AAAAAAAAAAo/9MRL_Nneumo/s1600/140610_002.jpg> >> Dario, the part number for the stud is 92900 - 080283B. I will upload a >> pic if I can figure how! >> >> On Saturday, May 31, 2014 2:43:02 PM UTC-2:30, Dario wrote: >>> >>> Hello! >>> >>> Could you please share with us the part number for the stud? >>> >>> Thank you >>> >>> On Saturday, May 31, 2014 7:05:16 AM UTC-4, 750S wrote: >>> >>>> Thanks everyone for your time. All info greatly appreciated. I was >>>> about to take the hardware store hunting route but first I went to my >>>> local >>>> Honda dealer and the parts guy actually found a part number and ordered 4 >>>> of them for me!! I figure I may as well replace all four. I was quite >>>> surprised that Honda had a part number cause when you look up any >>>> schematics online these studs are never shown seperately just as it shows >>>> in the Honda shop manual schematic of forks. Thanks again. >>>> >>>> On Friday, May 30, 2014 3:10:41 PM UTC-2:30, 750S wrote: >>>>> >>>>> I was reinstalling my front wheel today after having new tire >>>>> installed when 1 of the 4 axle retainer studs that protude from the lower >>>>> fork tube snapped off. I got the remainder of the stud out of the fork >>>>> with >>>>> ease. I'm wondering if someone knows where I might be able to get these >>>>> studs or what the correct metric dimensions are for these studs? Has >>>>> anyone >>>>> else had this same problem. I was just bringing it up to the correct >>>>> torque >>>>> when it snapped! ( 18-25 newton metres) Can't seem to find any info on >>>>> buying these studs sepaerate online other than a complete fork >>>>> assembly!!!! >>>>> HELP GREATLY APPRECIATED, Can't wait to start riding those new tires >>>>> for >>>>> the season. >>>>> >>>> -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/nighthawk_lovers. For more options, visit https://groups.google.com/d/optout.
