Lu, You can Copy nmfe5.bat to the project SPLUS project folder. This is a good practice, I copy the nmfe5.bat, the control stream and data files into a project folder. I use that folder as my SPLUS folder. This way, you can run your NonMem using the dos() command in SPLUS without having to specify a folder, and you'll have all input and output files in one place.
Malaz Malaz A. AbuTarif, B.Sc. (Pharmacy), Ph.D., G.C.P.M., M.B.A. Principal Scientist, Schering- Plough Research Institute 2015 Galloping Hill Rd, K-15-2-2650 Kenilworth, NJ 07033 Tel: (908) 740-3835, Fax: (908) 740-2916 [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Zheng Lu Sent: Tuesday, April 24, 2007 5:20 PM To: nmusers Subject: [NMusers] dos() function in s-plus to call NONMEM using the bootstrappeddata Dear All: Could someone tell how to use dos() in S-plus to run NONMEM for Bootstrapped Data. In my computer, NONMEM can be run in standard DOS window, my basic question is how to specify the path of .ctl file and .lst file, when I write dos('nmfe6 amiwr.ctl amiwr.lst')in s-plus, the message of no amiwr.ctl found was returned, even amiwr.ctl is already under c:\, thank you very much for your consideration and help. Zheng ********************************************************************* This message and any attachments are solely for the intended recipient. If you are not the intended recipient, disclosure, copying, use or distribution of the information included in this message is prohibited -- Please immediately and permanently delete.
