Hi, I am having a noxbox that I am trying to use a dumb switch, inclusive of the wireless interface. It appears that the setting puts of0 as the bridge. Can anyone explain why that is so, as specified in hostapd.conf? I have always thought that of0 is only for inband control.
Also, there is the question of where I have only one port registered (from dpctl dump-ports) when below is my configuration in noxbox.conf. I was expecting two interfaces (ath0 and eth0) and so shouldn't it show two ports? Any comments would be appreciated. Thanks in advance. Regards KK # The first port can be configured in four different modes: # pppoe (for use with PPPoE) # nat (does NAT on whatever is upstream) # on (it's just another port) # off (same as NAT and PPPOE, but no uplink) # dhcp (not added to the switch -- just configured by dhcp) # none (it is just left alone - primarily for use with panel daemon) PORT1_MODE=on # The second port can be configured in three different modes: # on (it's added to the openflow switch) # off (it is disabled) # debug (it's configured to a static IP address for debugging) # none (it is just left alone) PORT2_MODE=debug ....... # These interfaces will be added to the OpenFlow switch. Don't add eth0 and # eth1 here, since those are handled through the PORT1_MODE and PORT2_MODE # above (i.e. just set those to "on" if you want them on the OpenFlow switch). OPENFLOW_INTERFACES="ath0" _______________________________________________ nox-dev mailing list [email protected] http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org
