Hi Ricardo, Before you adding an event handler ( which is different from adding events in NOX ), did you run a component that does nothing? Try that. You can create to a new component using nox-new-c-app.py if you are using zaku or later. That component should just run.
After which, you can look at switch.cc for an example of how to register an event. That component should be simple enough for source-code reading. Let us know if you have other problems. Regards KK On 29 December 2010 06:57, Ricardo Bennesby <[email protected]>wrote: > Hi all. > I am writing a simple C++ component that prints a message for each packet > that arrives at Nox, as an introduction to developing a C++ component. The > component compiles without warnings, but an error occurs on execution: > > *'newcomp' ran into an error: > Can't open a dynamic library: 'nox/netapps/newcomp/newcomp.so: cannot > open shared object file: No such file or directory' or > 'nox/netapps/newcomp/.libs/newcomp.so: undefined symbol: > vigil::newcomp::handler(vigil::Event const&)' > * > I found a thread "Adding Events in Nox" that reported the same problem and > I followed the steps described there, but the error persists. Does anyone > have any suggestions to solve this? > > Regards. > > > -- > Ricardo Bennesby da Silva > Ciência da Computação - UFAM > LabCIA - Laboratório de Computação Inteligente e Autonômica > > > _______________________________________________ > nox-dev mailing list > [email protected] > http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org > >
_______________________________________________ nox-dev mailing list [email protected] http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org
