Hi Bob, I'm running this on the loopback interface in wireshark. I think I see whats going on.
If I run mn like this I don't see any of traffic in wireshark sudo mn --custom mytopo.py --topo mytopo --switch ovsk --controller remote --port 7777 Though If I run it like this I do: sudo mn --custom mytopo.py --topo mytopo --switch ovsk --controller remote (Note I do change the port that my controller is running on respectively.) Now that I can see the OF traffic I may be able to see where I'm going wrong. Thanks, Aaron On Wed, Feb 16, 2011 at 3:04 PM, Bob Lantz <[email protected]> wrote: > Hi Aaron, > > Which interface are you running wireshark on? > > For a controller running inside the VM, you should probably be looking at the > loopback interface. > > -Bob > > On Feb 16, 2011, at 11:59 AM, Aaron Rosen wrote: >> >> I'm trying to look at my openflow traffic with wireshark but for some >> reason I'm not seeing any. Though at my controller I'm definitely >> getting the packets. (I think this may because I'm using mininet? I've >> tried all the interfaces on my machine in wireshark). Though when I >> try this using the Openflow Tutorial provided VM i'm also not seeing >> any 'of' packets in wireshark there? (Any idea why)? >> >> Thanks, >> >> Aaron >> >> >> >> -- >> Aaron O. Rosen >> Masters Student - Network Communication >> 306B Fluor Daniel >> 843.425.9777 >> >> _______________________________________________ >> nox-dev mailing list >> [email protected] >> http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org > > -- Aaron O. Rosen Masters Student - Network Communication 306B Fluor Daniel 843.425.9777 _______________________________________________ nox-dev mailing list [email protected] http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org
