Hi:everyone
I am a person new to NOX and OpenFlow. Thanks you very much.
I use OpenFlow1.0 and original NOX0.6 building system,as shown below.
=======
+ NOX +
=======
|189.81.50.99/24
|
|
ETH1 | 189.81.50.77/24
=========
PC1------------------ +OpenFlow+------------------PC2
140.1.1.1/24 Eth0=========Eth2 140.1.1.2/24
We can add flow using './dpctl add-flow ' on OpenFlow,but I can not find any
command on NOX,including add-flow command?del-flow command and so on.
Is there command line on NOX? If it exists,please tell me, thanks a lot.
This e-mail and its attachments contain confidential information from HUAWEI,
which
is intended only for the person or entity whose address is listed above. Any
use of the
information contained herein in any way (including, but not limited to, total
or partial
disclosure, reproduction, or dissemination) by persons other than the intended
recipient(s) is prohibited. If you receive this e-mail in error, please notify
the sender by
phone or email immediately and delete it!
_______________________________________________
nox-dev mailing list
[email protected]
http://noxrepo.org/mailman/listinfo/nox-dev
