hi
Thank you very much for your reply
Is these values for parameters of energy valid ????
-rxPower 0.01\
-txPower 0.03\
-initialEnergy 10
please help me
thanks
Paramasivam <[EMAIL PROTECTED]> wrote: this mainly depends on your
application, if yours is a battery operated device then the initial energy is
in the range of 2 Joules and the Transmitting and Recieving power will be in
the range of micro or pico watts.
i think that for your application, you may use an initial battery of 10
Joules and the transmitting and receiveing power can be in milli watts.
--
---------
With Regards,
M.E.Paramasivam ,
Researcher,
Sona College of Technology,
Salem - 636 005,
Tamil Nadu,
INDIA.
GSM - +91 9442604410
Hi All,
Could someone help me . I need to determine values for parameters of the
energy model. P_rx, P_tx, and initialenergy.
-energyModel $energymodel \
-rxPower $p_rx \
-txPower $p_tx \
-initialEnergy $initialenergy
I use mobile node and traffic model of the VoIP session considered
employed G.729 codec for which the payload is 10 Bytes and
packet rate is 50 packets per second (UDP protocol).
Simulation time 300 sec.
Please help me.
Thanks a lot.
---------------------------------
Don't get soaked. Take a quick peak at the forecast
with theYahoo! Search weather shortcut.
