Hi Chandrabhan,

Usually Segmentation fault in DSR routing protocol occur due to using wrong
interface queue.

In your code just check the "ifq" section.

Make sure your ifq is set to "*CMUPriQueue*" for DSR routing protocol and
not "*Queue/DropTail/PriQueue*"

On Mon, Nov 14, 2011 at 11:42 AM, Chandrabhan Pradhan <
chandrabhanprad...@gmail.com> wrote:

>
>
> Hi NS Buddies,
>
>           I have a simple DSR analysis program with One source and one
> destination node. It was working fine, producing graphs for Packet Loss,
> Throughput and delay.
> Now I am increasing the source node (2 now), so I just generated new Agent
> (UDP), new CBR traffic source and attached it to new source node.
>
> But it gives out me the error segmentation fault. please help.
> Sorry I forgot to attach my source code so again sending the same mail with
> the same.
>
> --
> --
> Thanx & Regards
>
> Chandrabhan Pradhan
> MTech
> OPJIT, Raigarh
> 9993559009
> <#@NDR@B#@N
>
>


-- 
Thanks,
Ankur
+91-8975125485

Reply via email to