I have compiled and installed ntop v.3.0.050 (from CVS 04/05/2004) and
configured it to use sflow (configured sflow, turned the plugin on and
switched the NIC). However, when I restart ntop, the sflow plugin
doesn't start automatically. The configuration is still there (loaded
from the prefs db properly) and it says the plugin is running, but the
only NIC recognized is eth0. To get it to work, I have to turn the
plugin off and then on again (admin:plugins page), and then switch the
NIC to "sFlow-device" again.
I know this used to work in v.2.2.99.
Thanks,
Greg Paschall
--------
Greg Paschall -- [EMAIL PROTECTED]
SSL Network & IT Manager
Space Sciences Lab - University of California at Berkeley
Room 230 -- (510) 643-6907 -- Fax: (510) 643-7629
_______________________________________________
Ntop-dev mailing list
[EMAIL PROTECTED]
http://listgateway.unipi.it/mailman/listinfo/ntop-dev
