Hi Pavel
it looks like you are not using the PF_RING-aware driver 
(drivers/PF_RING_aware/intel/e1000e/e1000e-2.0.0.1)
"ethtool -i eth0" says "version: 1.5.1-k"

Regards
Alfredo

On Oct 17, 2012, at 1:32 AM, Павел Бушмакин <[email protected]> wrote:

> Hi everyone,
> 
> I have been testing pf_ring-aware drivers on performance and find this 
> problem. tx capture works normal.
> I have been sending packets with pfsend either on local machine and from the 
> remote with this command:
> $./pfsend -n 10000 -i eth0
> 
> capture was saying that there were no packets captured:
> $./pfcount -i eth0 -e 1
> 
> I have used latest pf_ring (5.4.6-r5751) and driver (e1000e-2.0.1). There was 
> deffenitly some other constant traffic on this device (checked with tcpdump). 
> At first i compiled and loaded e1000e then pf_ring with transparent_mode=1. 
> Here is some info on my machine:
> $cat /proc/net/pf_ring/info 
> PF_RING Version     : 5.4.6 ($Revision: exported$)
> Ring slots          : 4096
> Slot version        : 14
> Capture TX          : Yes [RX+TX]
> IP Defragment       : No
> Socket Mode         : Standard
> Transparent mode    : Yes (mode 1)
> Total rings         : 2
> Total plugins       : 0
> 
> $ sudo ifconfig eth0
> eth0      Link encap:Ethernet  HWaddr some_hwaddr  
>           inet addr:soume_ip Bcast:some_bcast  Mask:255.255.255.0
>           inet6 addr: some_ipv6 Scope:Link
>           UP BROADCAST RUNNING PROMISC MULTICAST  MTU:1500  Metric:1
>           RX packets:2194 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:21320 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000 
>           RX bytes:218006 (212.8 KiB)  TX bytes:1545459 (1.4 MiB)
>           Interrupt:18 Memory:dfee0000-dff00000 
> 
> $cat /proc/net/pf_ring/dev/eth0/info 
> Name:              eth0
> Index:             4
> Address:           some_hwaddr
> Polling Mode:      NAPI/TNAPI
> Type:              Ethernet
> Family:            Standard NIC
> # Bound Sockets:   2
> Max # TX Queues:   1
> # Used RX Queues:  1
> 
> $ethtool -i eth0
> driver: e1000e
> version: 1.5.1-k
> firmware-version: 2.1-11
> bus-info: 0000:04:00.0
> 
> $lspci
> 09:00.0 Ethernet controller: Intel Corporation 82571EB Gigabit Ethernet 
> Controller (rev 06)
> 
> 
> -- 
> Bushmakin Pavel.
> 
> _______________________________________________
> Ntop-misc mailing list
> [email protected]
> http://listgateway.unipi.it/mailman/listinfo/ntop-misc

_______________________________________________
Ntop-misc mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop-misc

Reply via email to