Hi,
Yes after setting VLAN-based disaggregation i restart ntopng. No i
don't see any VLAN values greater than zero whitin ntopng. No any
interface come out from the Interfaces menu when enable VLAN
disaggregation. The only interface that i see are the local interface
of the VW where ntopng is installed and the nProbe interface of zmq,
the same that i see when i select none like disaggregation level
Simone Mainardi <[email protected]> ha scritto:
Hi,
Do you see VLAN values greater than zero within ntopng? Did you
restart ntopng after setting VLAN-based disaggregation? Does any new
interface come out from the Interfaces dropdown menu when the
VLAN-based disaggregation i enabled?
On 28 Jun 2018, at 03:22, Flavio Baccaglini
<[email protected]> wrote:
Good Morning
I have a ntopng/nprobe system that i use to collect the sflow data
from a switch. The version of ntopng is 3.4 stable. The system version
is Debian 9. My configuration of ntopng and nprobe are save in the
file that i enclose you. I want to make a dissagregation at VLAN
level, but when i set the value in preferences in ntopng the system
stop to collect the flow and don't do nothing. I try a disaggregation
level for interface and it works. Could someone help me, or tell me if
i have a configuration mistake o if there is an another problem?
Thank you for the help, and sorry for the bad english
Baccaglini Flavio
<nprobe.conf><ntopng.conf>_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop
_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop
_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop
