However, at least the configuration settings ARE retained from run to run...
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Christian Hammers Sent: Saturday, May 04, 2002 12:17 PM To: [EMAIL PROTECTED] Subject: Re: [Ntop] Ntop netflows not exported On Sat, May 04, 2002 at 01:13:37PM +0200, Adrian ISTRATE wrote: > Is there any parameter to set to tell ntop which interface/ip address to > use when exporting the flows? Of course :-) In old versions, like the stable 2.0.0 there was a command line parameter. For netflow exporting I would *strongly* suggest you to take the very latest CVS snapshot as the old version was not able to collect 30 records in one export packets and thus generated a huge amount of flow packets (and had other bugs, too). The new version is sadly only configurable via the web interface. There go to plugins, turn the netflow plugin on, click on it, configure the host (port only configurable via plugins/netflow.c) and select for which interfaces flows should be generated. For using netflow keep in mind that netflow is a input-based-border-router system, i.e. you may only account incoming, not outgoing packets on an interface which means that you need one instance of ntop with a very special filter setup for every network interface card you have in your router. bye, -christian- -- Christian Hammers WESTEND GmbH - Aachen und Dueren Tel 0241/701333-0 [EMAIL PROTECTED] Internet & Security for Professionals Fax 0241/911879 WESTEND ist CISCO Systems Partner - Authorized Reseller _______________________________________________ Ntop mailing list [EMAIL PROTECTED] http://listgateway.unipi.it/mailman/listinfo/ntop _______________________________________________ Ntop mailing list [EMAIL PROTECTED] http://listgateway.unipi.it/mailman/listinfo/ntop
