On Wed, 4 Jun 2003, Scott Stone wrote: > > sounds like a problem with your libz... perhaps use the one that comes > in the ntop tarball instead of the system one? (or vice versa, if you > used the one in the tarball already..) >
Well, I then tried installing the pre-built 2.2 RPM. It complained slightly about (I think) libpthread, so I loaded glibc-2.3.2-4.80.6.i686.rpm and friends. Still no joy. The third frame (where all the data is displayed) is still blank. So I updated zlib - grabbed zlib-1.1.4-8.8x.src.rpm, and built/ installed the two rpms that were produced. Still no joy. I'll try your suggestion now, maybe I'll have better luck... (me goes away and does stuff) No go - built with included zlib, built with zlib from 8.0, built with zlib from Rawhide. Seems to build fine every time, but all attempts to load that frame seem to produce: ntop[5378]: **WARNING** gzflush error -2(stream error) Is there any way (I didn't notice one in configure) to disable zlib compression? Best regards, Dave -- -------------------------------------------------------- Dave Lugo [EMAIL PROTECTED] LC Unit #260 TINLC Have you hugged your firewall today? No spam, thanks. -------------------------------------------------------- Are you the police? . . . . No ma'am, we're sysadmins. _______________________________________________ Ntop mailing list [EMAIL PROTECTED] http://listgateway.unipi.it/mailman/listinfo/ntop
