Read the docs/FAQ articles on switches. 1. Probably - that or see Craig's answer. 2. No 3. That's really the same ? as #1
-----Burton > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of > [EMAIL PROTECTED] > Sent: Monday, April 19, 2004 11:43 PM > To: [EMAIL PROTECTED] > Subject: [Ntop] Ntop and the Cisco Catalyst 2950 switches > > > Hello list, > > I'm presently trying to install and run Ntop version 3.0 on a large > network where the Cisco Catalyst 2950 switches is used to connect systems > together. Ntop install correctly but cannot see all trafic on the network. > I just get small amount of information (>= 400kb) and nothing else on > every monitored servers. Even if a try to transfert large amount of data > (50MB or less) nothing are displayed into the reported page. Does somebody > on this list have an idea about the problem? I'm pretty sure that someone > know what the problem is because cisco switches are often used onto > entreprises. > > 1- Does I've to use the Netflow/sflow feature of ntop with the Cisco > Catalyst 2950 switches to make it work? > > 2- Does using eth0 is enought to make it work with the Cisco Catalyst 2950 > switches? > > 3- Does I've to enable/configure something into the Cisco Catalyst 2950 > switches to make it work? > > Any comments are welcome and I thank you for your answer. > > Gerhard, > _______________________________________________ > Ntop mailing list > [EMAIL PROTECTED] > http://listgateway.unipi.it/mailman/listinfo/ntop _______________________________________________ Ntop mailing list [EMAIL PROTECTED] http://listgateway.unipi.it/mailman/listinfo/ntop
