Read the back traffic - there are two kinds of sFlow packets and you probably need to be receiving the other. IIRC on is a summary and one is detailed - the summary get received by ntop, counted, listed in the debug messages and thrown away.
-----Burton > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of > Bret Jordan > Sent: Monday, July 12, 2004 3:10 AM > To: [EMAIL PROTECTED] > Subject: [Ntop] Question > > > I am trying to use NTOP with SFLOW data from my Foundry BigIron. Ntop > appears to be running correctly (I started it with./ntop -w 3000 -d). I > went into the admin section and turned on SFLOW, added the UDP port > number that I am sending data to, I also switched the NIC to sflow. > When I go into the logs it show data, but there is nothing in any of the > summary charts or protocol charts. What am I doing wrong?? > > BTW on my BigIron I did: > > GLOBAL: > Sflow enable > Sflow destination <ip address> > > INTERFACE COMMANDS: > Sflow forwarding > > > > Bret > > -- > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Bret Jordan Dean's Office > Director of Networking College of Engineering > 801.585.3765 University of Utah > [EMAIL PROTECTED] > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > _______________________________________________ > Ntop mailing list > [EMAIL PROTECTED] > http://listgateway.unipi.it/mailman/listinfo/ntop _______________________________________________ Ntop mailing list [EMAIL PROTECTED] http://listgateway.unipi.it/mailman/listinfo/ntop
