I think you mis-understand the protocol list - it identifies which tcp/ip
protocols (port numbers) ntop monitors.  That set is then used for ALL
reports, with unlisted ports falling into "Other".  If given, the parameter
replaces the default list (see docs/FAQ for that).

If you need to filter (in or out) specific protocols, etc. across ntop, look
at the man page for the -B "filter" switch.  This BPF expression controls
the packets ntop sees.  While people usually think of filters as "host
this.someone.nl" or "net 192.168.0.0/16", you can in fact specify the
protocols, e.g. "IP".  The man page for tcpdump gives some examples.

-----Burton


-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of
C2SC/Proj/Munster
Sent: Tuesday, April 19, 2005 9:36 AM
To: '[email protected]'
Subject: [Ntop] Ntop All Protocols|Traffic formatting?

Hello,


For the Dutch Army we are investigating the usage of ntop as a NetFlow
collector and reporting tool. This will possibly be implemented in the
TITAAN network, which is used for army and airforce missions abroad.

With the '-p' switch on ntop we can format the output of IP|Summary|Traffic
by specifying a protocol list. My question: is there also a possibility to
format the All Protocols|Traffic output by specifying a list of protocols
(e.g. only TCP, UDP, ICMP, OSPF, PIM, ESP, and IGMP)? If so, is there a
(hidden) switch to use?

Thanks for replies and suggestions!


Cees.


Cees van Munster
Royal Netherlands Army
Project TITAAN
Network Architect
_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop

_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop

Reply via email to