Hi Rivalino, It may not be the same for your telco, but many Frame Relay links are sold with two speeds, basically a minimum, which is generaly what you've ask for and pay for, and a maximum (based on the shared bandwidth of the circuit), they have some funky names like CIR and DIR or something (it's been too long, I can't remember).
So it's quite possible that you will see bursts of traffic that go above the contracted rate for a given link. Onother way to check this, might be to get NTOP to get a netflow feed from the router at the other end, or use something like MRTG to monitor the interfaces and double check the traffic levels that way. Of course, any monitoring you do is going to increase the bandwidth that you use :) Hope that helps. Later'ish Craig > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On > Behalf Of Rivalino Matias Jr. > Sent: Sunday, October 30, 2005 11:14 AM > To: [EMAIL PROTECTED] It > Subject: [Ntop] Network Throughput > > Hello guys, > > I have a linux box configured as linux bridging and running > ntop. I have this box positioned between a WAN router and a > LAN switch, like follows: [snip snip] _______________________________________________ Ntop mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop
