We do the quick config instead of following the GUI in smartstart. Then we
load the server O/S wiht our unattended builds. You can access the quick
config by pressing F10 once the GUI just starts, ie that red screen with the
van , etc. appears. Then you can choose the language and then you get a menu
to choose what to install. For example we choose 1 for english and then 2 to
Configure System and create System Partition.
You can also use their scripting tools to create a pre-canned config and just
flash it completely in an unattended build, skipping the smartstart
completely. This however requires that same hardware, cards, cards in the same
slots, etc.
Thanks
"Martin Blackstone"
<mblackstone@superiora To: "NT System Admin Issues"
ccess.net>
<[EMAIL PROTECTED]>
cc:
08/28/2001 10:07 AM Subject: SmartStart Question
Please respond to "NT
System Admin Issues"
As I mentioned here before, it has been a number of years since I worked with
Compaq equipment.
And it also appears that I was never properly instructed in the use of
SmartStart. But since I am such a wizbang kid these days, I have figured it
out.
But I wonder one thing. Do you guys recommend doing the Manual or the
Automated setup routine?
Just so we are all on the same page, this would be SS5 and W2K
Martin Blackstone
Director, Information Technologies
Superior Access Insurance Services
949.470.2111 x279
http://www.sunbelt-software.com/ntsysadmin_list_charter.htm
http://www.sunbelt-software.com/ntsysadmin_list_charter.htm
