We have temperature probes that send snmp traps to Nagios to send messages
when they get to a certain levels (warn, critical).  We have one center of
the server room probe that reports the ambient room temperature, the
remaining probes are scattered through the server room behind the servers
inside the racks.  Based on the server to rack ratio, we have these set
alerts set at different levels for each rack.  The more servers in a rack
the lower the warn level temp is, the fewer number of servers in a rack, the
higher the temp warn levels are.  In an HVAC event, we have a procedure of
what to shut down to keep critical production servers up, but keep temps
within acceptable ranges.  All HP servers in our server room, and our shut
down threshold is ~95 ambient room temp.  We're also about 80% virtual
guests, so a good number of our physical servers are actually virtual
hosts.  In a HVAC event, I could get to the point that I have half of my
virtual hosts shut down if necessary.

On Wed, Jun 3, 2009 at 10:04 AM, Tim Vander Kooi <[email protected]>wrote:

> In a well designed room the temperature should be relatively even with the
> only "hotspot" being directly behind the servers. Front, side, top and
> bottom temps should be very close to the same.
> TVK
>
>
> -----Original Message-----
> From: David W. McSpadden [mailto:[email protected]]
> Sent: Wednesday, June 03, 2009 7:34 AM
> To: NT System Admin Issues
> Subject: Re: PROPER OPERATING TEMPERATURES FOR SERVERS
>
> Even if you keep the room in the mid 70's you should get a reading right
> next to the servers in the rack you will see about a 15 to 20 degrees
> difference.  Tell your boss it is like running a temperature yourself.  You
> can survive and function at 104 degrees but you are miserable, you don't
> give accurate information, and you are sluggish.  You could possible slip
> into a coma if your temp goes up a degree or two and you could lose brain
> function and memory loss.  If that is what he wants by saving a few dollars
> then yeah raise.  Hell shut it off and hope the internal fans keep it cool
> enough.  If the AC is pulling to much power maybe a wiser approach is to
> get
> an energy efficient AC unit...
> Just my thoughts.
>
> ----- Original Message -----
> From: "Steven M. Caesare" <[email protected]>
> To: "NT System Admin Issues" <[email protected]>
> Sent: Wednesday, June 03, 2009 8:25 AM
> Subject: RE: PROPER OPERATING TEMPERATURES FOR SERVERS
>
>
> > Eh?
> >
> > I've had racks of HPs running @ 100+ during HVAC events...
> >
> >
> > -sc
> >
> > -----Original Message-----
> > From: Maglinger, Paul <[email protected]>
> > Sent: Wednesday, June 03, 2009 8:20 AM
> > To: NT System Admin Issues <[email protected]>
> > Subject: RE: PROPER OPERATING TEMPERATURES FOR SERVERS
> >
> > I'm surprised they run at that temp.  HP servers will typically shutdown
> > around 90F.
> >
> > -----Original Message-----
> > From: Phil Brutsche [mailto:[email protected]]
> > Sent: Tuesday, June 02, 2009 5:27 PM
> > To: NT System Admin Issues
> > Subject: Re: PROPER OPERATING TEMPERATURES FOR SERVERS
> >
> > I've got a cheapskate boss so I've run them 95F+ for long periods of
> > time.
> >
> > They're not properly rackmounted - due to our crappy and proprietary
> > Panduit racks we have no choice but to use shelves - which may have
> > helped them survive.
> >
> > Don't be surprised if you get warranty rejections from the excessive
> > heat.
> >
> > Murray Freeman wrote:
> >> Like many companies these days, we're looking to reduce our expenses.
> >> With the hot weather almost here in the Chicago area, I'm being asked
> > to
> >> up the thermostat in our server room, to allow it to get warmer and
> > thus
> >> save some money. We have been keeping the temperature around the mid
> >> 70's, and I'm concerned about higher temps in the server room causing
> >> servers to crash or at least reduce their lifetime. What od you think
> > is
> >> the maximum operating temperature for a room with servers? We humans
> > are
> >> not in the room that often, so it's strictly a case of a safe
> >> temperature for the hardware. There's no need to determine how many
> >> servers I have or how large the room is, just the temperature
> > necessary
> >> to safely operate servers.
> >
> > --
> >
> > Phil Brutsche
> > [email protected]
> >
> > ~ Finally, powerful endpoint security that ISN'T a resource hog! ~
> > ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/>  ~
> >
> > ~ Finally, powerful endpoint security that ISN'T a resource hog! ~
> > ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/>  ~
> >
> >
> > ~ Finally, powerful endpoint security that ISN'T a resource hog! ~
> > ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/>  ~
> >
>
>
>
> ~ Finally, powerful endpoint security that ISN'T a resource hog! ~
> ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/>  ~
>
> ~ Finally, powerful endpoint security that ISN'T a resource hog! ~
> ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/>  ~
>
>


-- 
Sherry Abercrombie

"Any sufficiently advanced technology is indistinguishable from magic."
Arthur C. Clarke
Sent from Haslet, TX, United States

~ Finally, powerful endpoint security that ISN'T a resource hog! ~
~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/>  ~

Reply via email to