Hi Magno,
could you send some of the Python you've been trying?
Thanks,
Wouter
On 03/01/2012 16:45, Magno Borgo wrote:
Another question on the same subject. Is it possible to create Shapes
inside spline warp nodes via Python scripting? Because i'm trying to
apply some of the rotopaint python exemples on the node and its not working.
What I'm missing?
Magno.
Hi all,
The way source and destination curves work will change for the next
major version of Nuke, but in 6.3 the source and destination are
essentially the same curve, similar to Roto and it's feather curve.
(Hence the awkward naming..)
Regards,
Wouter
-- Sent from my HP Pre3
------------------------------------------------------------------------
On 15 Dec 2011 01:28, Magno Borgo <[email protected]> wrote:
Yeah the naming was not helping! Thanks Ivan, that was exactly what
i needed.
Magno.
Each control point has both the source and destination
attributes. The confusing part is that the naming of those
attributes makes more sense for a standard roto shape.
So, your source curve is:
controlPoint.center
and the dest curve is:
controlPoint.featherCenter
Also, if you're getting the position data out of each attribute,
keep in mind that the dest points are stored as an offset
relative to the src point, instead of an absolute position.
Have a look at the output of this:
node = nuke.selectedNode()
curves = node['curves']
sourcecurve = curves.toElement('Bezier1')
for p in sourcecurve:
print p.center.getPosition(nuke.frame()),
p.featherCenter.getPosition(nuke.frame())
Hope that helps.
Cheers,
Ivan
On Wed, Dec 14, 2011 at 4:21 PM, Magno Borgo <[email protected]
<mailto:[email protected]>> wrote:
Hello!
I trying to figure out how to access the *control points *of
the***destination* curves of the SplineWarp node via python.
The points of the source curves are easy:
node = nuke.selectedNode()
curves = node['curves']
sourcecurve = curves.toElement('Ellipse1')
With sourcecurve[0], sourcecurve[1], etc i can access each
control point.
Any help?
--
**************************
Magno Borgo
www.borgo.tv <http://www.borgo.tv>
www.boundaryvfx.com <http://www.boundaryvfx.com>
_______________________________________________
Nuke-users mailing list
[email protected]
<mailto:[email protected]>,
http://forums.thefoundry.co.uk/
http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users
--
**************************
Magno Borgo
www.borgo.tv
www.boundaryvfx.com
--
**************************
Magno Borgo
www.borgo.tv
www.boundaryvfx.com
_______________________________________________
Nuke-users mailing list
[email protected], http://forums.thefoundry.co.uk/
http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users
--
Wouter Klouwen, Software Engineer
The Foundry, 6th Floor, Comms Building, 48 Leicester Sq, London WC2H LT
Tel: +442079686828 • Fax: +4420 79308906 • thefoundry.co.uk
The Foundry Visionmongers Ltd • Reg.d in England and Wales No: 4642027
_______________________________________________
Nuke-users mailing list
[email protected], http://forums.thefoundry.co.uk/
http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users
