Thanks Michael. I have tried that before using something like this: ((root.format.width/2) - (center.x)) ((root.format.height/2) - (center.y))
The problem is that when I deselect the shape or create a new shape it freaks out and disregards the position change. I believe it's because I am using center.x and center.y instead of hardcoding the values. If I can figure out how to call the center values by the shape name it should work. I'll try to figure that out! -- Nick On Tue, May 14, 2013 at 2:36 PM, michael vorberg <[email protected]>wrote: > select all of your roto points then go to the transform tab of this > shape and do a little math > in the translate input enter: half of your resolution - value from center > of this shape selection > do this for x and y and your already created shape should now have its > center on the center of the frame > > e.g. if your resolution is 1920x 1080 and the shape you create has the > center at 763x, 452y you would do > translate x = 1920/2-763 = 197 > translate y = 1080/2 - 452 = 88 > > Am 14.05.2013 23:20, schrieb Nick Guth: > > Thanks for the input. I've done both work arounds, but was hoping there > was something I overlooked. I guess I should submit a feature request! > > > _______________________________________________ > Nuke-users mailing [email protected], > http://forums.thefoundry.co.uk/http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users > > > > _______________________________________________ > Nuke-users mailing list > [email protected], http://forums.thefoundry.co.uk/ > http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users > -- Nick Guth motion . composite . design www.nickguth.com
_______________________________________________ Nuke-users mailing list [email protected], http://forums.thefoundry.co.uk/ http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users
