right click on CV > add expression.
Remember that the values of the Transform.translate knob are relative
offsets from the lower left corner, not absolute positions.
So you could set a single key frame on all CVs to store their original
position (happens by default when you create the spline), then use an
expression like "curve + Transform1.translate" on the main.x and main.y
knobs.
This may be easier done in the curve editor though, so I'd select all
CVs first, load them into the CE, then take it from there.
Cheers,
frank
On 3/7/14, 6:05 PM, adam jones wrote:
Hi all
I am trying to copy / link values from a transform node to individual points on
a spline warp curve.
I have tried to do this in every way shape and form but on each occasion the
point get moved to the lower left corner of the frame
they do in fact have the translation on them but all in the lower left corner,
this occurs no mater where the points start out.
also the first position of the transform values are the same as the as the
potion of the point in the spline curve.
just a final note each point gets a translation from a different transform node.
cheers
-adam
_______________________________________________
Nuke-users mailing list
[email protected], http://forums.thefoundry.co.uk/
http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users
_______________________________________________
Nuke-users mailing list
[email protected], http://forums.thefoundry.co.uk/
http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users
