Hello, I've investigated some new commands (variables) for Victron/GE UPS. Unfortunatelly, I'm not a good programmer, so I cannot to modify the driver code by myself. May be, is it possible to add these variables to the main project?
Variables are: ------------------------------------------------------------------------------------------------ GET: vZ1f? "no load shutdown (i.e. green mode)" EEPROM value, exists always 1 - disabled 2 - enabled SET: vZ1f_! where _ is the value in text (1,2) RETURNS: vZ1f_ ------------------------------------------------------------------------------------------------ GET: vFh? "audible status (i.e. beeper status)" may be a RAM value, exists until UPS restarts 1 - disabled 2 - enabled 3 - muted (for current alarm only) SET: vFh_! where _ is the value in text (1,2,3) RETURNS: vFh_ ------------------------------------------------------------------------------------------------ Investigated via port monitoring tool and then tested with my GE Match 700 with terminal. Best regards, Ilja _______________________________________________ Nut-upsdev mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsdev
