Since this driver is marked "experimental", I suppose we can add that
without worrying too much.
Any objections from the other developers?
On Jul 28, 2009, at 3:09 AM, [email protected] wrote:
Yes, it's should be correct..but It is advise to setup the port's
speed before start any communication...probably port's speed was set
to default to 115200 or
38400, but this speed was too fast to read any status change from ups.
Il giorno 28/lug/2009 02.37, Charles Lepple <[email protected]> ha
scritto:
> On Mon, Jul 27, 2009 at 11:19 AM, [email protected]> wrote:
>
> > Hi!
>
> >
>
> > My Liebert Power Sure PSPXT 450 with standard driver doesn't
works, so I've
>
> > done this modification and now it's works.
>
> >
>
> > # diff liebert_MY.c liebert.c
>
> > 178
>
> >
> > ---
>
> >>
>
> >
>
> > That is, I've only setup the port's speed.
>
>
>
> If the comments in the code are correct, it should not matter what
the
>
> baud rate was set to (the TX and RX pins are apparently connected
>
> together when on battery).
>
>
>
> Do you know what speed your serial port was using before that fix?
>
>
>
> --
>
> - Charles Lepple
>
>
_______________________________________________
Nut-upsdev mailing list
[email protected]
http://lists.alioth.debian.org/mailman/listinfo/nut-upsdev
