Hi I have just purchased a Cyberpower CP1300EPFCLCD UPS.
It is not listed in your Compatibility List http://networkupstools.org/stable-hcl.html I am very new to all this but do have a background in IT. I have been retired for 18 years so am a bit out of touch so please excuse if I am a bit fuzzy. I will try my best to explain my issue below. When I plug my UPS into my Synology NAS DS216+II is identifies it as a CP1500AVRLCD and uses the "usbhid-ups" which is based on publicly available protocol so the list says. The DS216 is acting as a NUT server and I have two Raspberry Pi's (RPi's) running Debian "Jessie" and running "nut-client" so that they can be gracefully shut down if a low battery signal is sent from the NUT server on the NAS. Hopefully the NAS will also shutdown after the clients. I have done a simulated mains failure and the loss of mains is transmitted to the clients from the server. My agenda is to try and get the two incorrect values to be correct. Everything works pretty well with the exception of two values. The Battery Voltage should be 24V as it's a 2 x 12V system connected in series. The OUTPUT voltage should be about 240-245V but is shown about 260 and I have seen values up to 265V I have checked the OUTPUT VOLTAGE on the UPS front panel and it's showing the correct value, that is if the input voltage is 242V then the panel is showing 242V as output voltage. This is what I get when I run " upsc ups@10.0.0.125" where 10.0.0.125 is in LAN IP address of NUT Server running on my Synology DS216+II NAS. The highlighted values are the incorrect ones. Init SSL without certificate database battery.charge: 100 battery.charge.low: 10 battery.charge.warning: 20 battery.mfr.date: CPS battery.runtime: 3990 battery.runtime.low: 300 battery.type: PbAcid battery.voltage: 16.0 battery.voltage.nominal: 24 device.mfr: CPS device.model: CP1300EPFCLCD device.serial: CTNGO2000027 device.type: ups driver.name: usbhid-ups driver.parameter.pollfreq: 30 driver.parameter.pollinterval: 5 driver.parameter.port: auto driver.version: DSM6-1-15205-171017-1-gf424baa driver.version.data: CyberPower HID 0.3 driver.version.internal: 0.38 input.transfer.high: 260 input.transfer.low: 170 input.voltage: 243.0 input.voltage.nominal: 230 output.voltage: 260.0 ups.beeper.status: enabled ups.delay.shutdown: 20 ups.delay.start: 30 ups.load: 6 ups.mfr: CPS ups.model: CP1300EPFCLCD ups.productid: 0501 ups.realpower.nominal: 780 ups.serial: CTNGO2000027 ups.status: OL ups.test.result: No test initiated ups.timer.shutdown: -60 ups.timer.start: -60 ups.vendorid: 0764 Can you help me please. Thank you Ron Taylor Cairns Nth Qld Aust.
_______________________________________________ Nut-upsdev mailing list Nut-upsdev@lists.alioth.debian.org http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsdev