Hi,
I've got a Powerware Prestige 9 1kVA UPS that seems to not be working with
nut. It's not in the current "supported hardware" list, but the old
bcmxcp page lists it as being a UPS that speaks that protocol.
I have the following in my ups.conf
[powerware]
driver = bcmxcp
port = /dev/ttyS0
desc = "Powerware Prestige 9 EXT"
baud_rate = 2400
And when I start the driver I get
root% upsdrvctl -v start
Network UPS Tools - UPS driver controller 2.0.4
exec: /lib/nut/bcmxcp -a powerware
Network UPS Tools - BCMXCP UPS driver 0.10 (2.0.4)
Connected to UPS on /dev/ttyS0 baudrate: 2400
Model = Powerware Prestige 1000VA
Firmware = 01.06
Shutdown delay = 120 seconds
Communications with UPS lost: Receive error (Request command): 9!!!
Communications with UPS lost: Receive error (Request command): 9!!!
Communications with UPS lost: Receive error (Request command): 9!!!
Communications with UPS lost: Error executing command
Could not communicate with the ups: Success
Driver failed to start (exit status=1)
So it's definitely talking to the UPS: it gets the model number and
firmware revision, neither of which are things I've told it. But then
there are errors and the driver finally gives up.
Can anyone give me a hand getting this working?
-Kipp
_______________________________________________
Nut-upsuser mailing list
[email protected]
http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
