Alexander I. Gordeev <[EMAIL PROTECTED]>:
> Yes, sure. I think, you'll also want to install udev and hotplug rules to
> setup device permissions automatically as well.
Where are those rules? Is their installation procedure documented anwhere?
> You only need these lines in ups.conf now:
>
> [myups]
> driver = megatec_usb
> port = auto
>
> After this you can control the driver with upsdrvctl tool:
>
> upsdrvctl start myups
Results aren't so good. Driver still starts up on its own, but...
[EMAIL PROTECTED]:/home/esr/svn/nut/trunk# upsdrvctl start myups
Network UPS Tools - UPS driver controller 2.1.0
Network UPS Tools 2.1.0 - Megatec protocol driver 1.5.3 [megatec_usb]
Carlos Rodrigues (c) 2003-2007
Serial-over-USB transport layer for Megatec protocol driver [megatec_usb]
Driver failed to start (exit status=1)
[EMAIL PROTECTED]:/home/esr/svn/nut/trunk#
That is a really uninformative error message. How do I troubleshoot this?
--
<a href="http://www.catb.org/~esr/";>Eric S. Raymond</a>
_______________________________________________
Nut-upsuser mailing list
[email protected]
http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
