On Sat, 19 Jul 2008 04:32:42 +0400, Andrej Podzimek <[EMAIL PROTECTED]> wrote:
>>> Asking for UPS status [Q1]... >>> get_data_agiler: raw dump: (0 bytes) => >>> get_data_agiler: raw dump: (0 bytes) => >>> Q1 => FAILED [short read] >>> Q1 detail: (0 bytes) => >>> 5 out of 5 detection attempts failed (minimum failures: 2). >>> Megatec protocol UPS not detected. >>> >>> What does that mean? Sounds like a broken UPS... :-( >> >> Try if adding a different 'subdriver' (see 'man 8 megatec_usb') works. >> This driver also supports one additional subdriver that isn't listed, >> 'agiler-old' (the manpage is outdated in this aspect). >> >> Best regards, Arjen > > Tried agiler-old, which failed the same way as the default subdriver. Output > from krauler: > > Checking device (0F03/0001) (001/008) > - VendorID: 0f03 > - ProductID: 0001 > - Manufacturer: Ver 1.0 > - Product: USB To RS232 Interface (V1.0) BaudRate 2400bps > - Serial Number: unknown > - Bus: 001 > Trying to match device > Device matches > Starting UPS detection process... > Asking for UPS status [Q1]... > set_data_krauler: index [03] > - Unable to fetch string 3 > set_data_krauler: connection failure > ser_send_pace: Device detached? (error -27: No error) > ================================================== > = device has been disconnected, try to reconnect = > ================================================== > > Again, there were five attempts to make a connection and all of them failed. > Disconnecting and reconnecting the UPS did not help. This is somewhat > strange. Are there any more subdrivers to try? > > Best regards, > > Andrej > The only way I see is to watch USB traffic of a Windows driver (if you have one) and understand what is the problem. You can use usbsnoop: http://benoit.papillault.free.fr/usbsnoop/ -- Alexander _______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
