Hello again! Thanks to the precious help from Henning Brauer, I managed to solve an issue with my UPS (a rebranded UPS speaking in Ablerex-ese over USB). Under OpenBSD 4.3, the UPS was claimed by HID. Now that I recompiled the kernel, adding a USB_quirk, this is what I get when I insert the USB cable:
ugen0 at uhub0 port 2 "UIS_ABLER USB to Serial" rev 1.00/1.00 addr 2 So far, so good (Henning confirmed this). Trouble is, when I run megatec_usb: [EMAIL PROTECTED]:~/nut-2.2.2 # drivers/megatec_usb -u _ups -a atlantisland -DDDDDD Network UPS Tools 2.2.2 - Megatec protocol driver 1.5.14 [megatec_usb] Carlos Rodrigues (c) 2003-2008 Serial-over-USB transport layer for Megatec protocol driver [megatec_usb] Andrey Lelikov (c) 2006, Alexander Gordeev (c) 2006-2007, Jon Gough (c) 2007 debug level is '6' No appropriate HID device found No supported devices found. Please check your device availability with 'lsusb' and make sure you have an up-to-date version of NUT. If this does not help, try running the driver with at least 'vendorid' and 'subdriver' options specified. Please refer to the man page for details about these options (man 8 megatec_usb). Please report your results to the NUT user's mailing list <[email protected]>. This is my ups.conf: [atlantisland] driver = megatec_usb port = /dev/tty00 desc = "Atlantis Land 1501" I tried, just in case, port = /dev/ugen0.00 but, as I have been pointed before, this is irrelevant. Here's the equivalent of a lsusb: [EMAIL PROTECTED]:~/nut-2.2.2 # usbdevs -vd Controller /dev/usb0: addr 1: full speed, self powered, config 1, UHCI root hub(0x0000), VIA(0x1106), rev 1.00 uhub0 port 1 powered port 2 addr 2: low speed, power 100 mA, config 1, USB to Serial(0x0000), UIS_ABLER(0x0001), rev 1.00 ugen0 also made ugen r/w to user _nut, as suggested in a tutorial: [EMAIL PROTECTED]:~/nut-2.2.2 # ll /dev/ugen0* crw-rw-rw- 1 root wheel 63, 0 Jun 2 21:25 /dev/ugen0.00 crw-rw-rw- 1 root wheel 63, 1 Jun 2 21:25 /dev/ugen0.01 crw-rw-rw- 1 root wheel 63, 2 Jun 2 21:25 /dev/ugen0.02 I am a bit lost. Please note that I have the same UPS up and running under Linux (same nut, 2.2.2), so I know it is supported. Thanks in advance for any suggestions --Vic _______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
