On Sun, Jan 31, 2010 at 2:52 AM, chance fulton <[email protected]> wrote: > I have 2 SmartUOS1050SLT's that apparently protocol 3004, has there been > any progress on getting these units supported under nut? I am running > version 2.4.1, and get the following output when starting the driver.
No progress - we have not received enough information from owners of Protocol 3004 units to proceed. From what little I can tell, 3004 uses binary values instead of ASCII (e.g. 0x01 instead of 0x31 to represent the number 1). Also, there seem to be other minor differences. The procedure for adding support for a new UPS protocol involves a lot of testing, and is best done without any critical loads attached (e.g. servers that you were trying to protect with the UPS in the first place). If you can take one unit offline for testing, we can work with you to add support, but there is always the danger that a wrong command will shut down the UPS before the attached computers are expecting it. -- - Charles Lepple _______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
