On 24/03/2011 13:01, Charles Lepple wrote:
How do things work if you add the "pollonly" option to the
configuration file?
I've just tried this, and the USB debug messages stopped on restart.
Really appreciate the help.
Be sure that the measured values shown in upsc are updating as well.
With the "pollonly" flag, they should be explicitly requested via
control messages, and you should see error messages if those control
messages fail, but that's making a lot of assumptions about the USB
stack.
Thanks for pointing that out. Just did some timing and found that with
and without the "pollonly" flag set, the ups.load value was changing
when applying and removing additional load. I did however notice that
the time taken to register the load change could be between 0 and 20
seconds, thought this could be down to the UPS itself, and not the drivers.
I've seen no errors being reported, so I'll cross my fingers!
_______________________________________________
Nut-upsuser mailing list
[email protected]
http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
