Charles, Thanks for your reply, however..
>> Nut-names.txt states that >> 1. ups.start.auto controls whether the UPS starts when mains is >> (re)applied. >> 2. shutdown.stayoff causes "turn off the load possibly after a delay >> and remain even if power returns". >> 3. shutdown.return causes "turn off the load possibly after a delay >> and return when power is back". >> >> 1 seems to conflict with 2 and 3. That is, 2 implies that ups.start.auto=no >> and 3 implies that ups.start.auto=yes. > My understanding of the "ups.start.auto" setting is that it only applies when > an explicit shutdown command has not been > given (and therefore would be > overridden by one of the shutdown.* commands, if NUT is configured to manage > the shutdown > process). That would be reasonable. If this is the intent then I suggest that that be said in the description of ups.start.auto in nut_names.txt. > That said, I'll defer to someone who knows the specifics of the Eaton > hardware for information on how it should work. > The UPS firmware has a lot > of leeway in how the commands and settings are interpreted. My experience so far with the Evolution 1550 is that shutdown.stayoff only works correctly if ups.start.auto=no and that shutdown.return only works correctly if ups.start.auto=yes. Given that, shouldn't the NUT driver for this UPS set ups.start.auto as part of these shutdown commands? Thanks, Rich _______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsuser
