On Sat, Jun 28, 2014 at 10:05 PM, Steve Ballantyne <[email protected]> wrote: > Hello Charles, > > I think we are making progress! I grabbed nut using git, and applied > your patch without any problems. Getting to the point that I could > run a configure on my RPi - was something else. I found this blog > post, which was very helpful (for anyone else that may try it): > http://atelier-orchard.blogspot.com/2013/11/raspberry-pixf86-video-fbdev.html > It's not in English, but you get can get the general idea of how to > move along.
At some point I should grab another SD card and do a clean install, then write up that procedure for the NUT documentation. > Also, tripplite_usb failed to build for me with a bunch of undefined > errors. I was able to fix it by editing the Makefile and adding -lusb > to the LD_FLAGS. Odd, it should have picked that up. Do you have libusb*dev installed? (Also probably the compat package, since NUT expects the libusb 0.1 API). > So - here I am starting up nut in debugging level 5, and it looks > "promising"? :-) At this point, I would start upsd and verify that the numbers look good in upsc. You may want to keep the log running to check how the unit responds to the loss of AC power (again, with the lamp, and probably using a power strip to cut power - some APC units get weird when they aren't grounded). Also we would want to verify the low battery signal (I'm just guessing that it's the binary version of the 3003 protocol). After that, there are the shutdown commands. This one is a little tricky, since there are several timers involved. > 9.684297 send_cmd: sending 3a 56 a9 0d 00 00 00 00 '.V......' > 9.786346 send_cmd: received 56 02 00 0c 01 58 58 0d 'V....XX.' (OK) > 9.786612 Unknown number of switchable load banks: 0x01 Hmm, I thought I covered that case. No matter, it's just a warning. > 9.786779 Switchable load banks: 1 Does this match the vendor software? It doesn't look like NUT is committing the rest of the values, so I might need to look at that part again (or maybe that's a different debug level). If upsc is missing a lot of numbers that you see in the debug log, let me know. _______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsuser
