Hello, I am trying to get a SMART500RT1U working on CentOS and just receiving the following message when attempting to start the driver:
Network UPS Tools - Tripp Lite OMNIVS / SMARTPRO driver 0.20 (2.6.5) Warning: This is an experimental driver. Some features may not function correctly. Detected a UPS: Tripp Lite /TRIPP LITE SMART500RT1U Unknown input voltage range: 0x02 Unknown number of switchable load banks: 0x01 Unit ID: 65535 Unknown protocol (3005)Attached to Tripp Lite TRIPP LITE SMART500RT1U Unknown value for s[1]: 0x01 Here is the environment that it is running in: Environmental OS: Centos 6.6 Kernel: 2.6.32-504.8.1.el6.x86_64 Nut Version: nut-2.6.5-2.el6.x86_64 What would be my next step to getting this to communicate with this UPS? Whenever I run UPS after starting this driver it gives me Error: Driver not connected Eric Cobb [email protected] ________________________________ This message is for the addressee's use only. It may contain confidential information. If you receive this message in error, please delete it and notify the sender. Tripp Lite disclaims all warranties and liabilities, and assumes no responsibility for viruses which may infect an email sent to you from Tripp Lite and which damage your electronic systems or information. It is your responsibility to maintain virus detection systems to prevent damage to your electronic systems and information.
_______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsuser
