Hi all, I'm trying to configure Nut to connect to an APC BackUPS Pro 900VA. This ups uses a serial port on which _simple_ or _smart_ signaling should be spoken. I've connected the UPS to a serial port using the original 940_0128A cable from APC. Unfortunately I've not yet managed to read any data from the ups. If I try to load the apcsmart driver it tells me that it cannot communicate with the ups.
Does anyone be able to configure Nut so that the mentioned BackUPS is recognized properly. If someone could give me a hint how I need to configure nut, I would appreciate it. Just to mention, Nut is already working with older SmartUPS devices without any problems. So it isn't a general but a device specific problem. Thank you in advance! Regards Juergen -- Mail: juer...@eisfair.org _______________________________________________ Nut-upsuser mailing list Nut-upsuser@lists.alioth.debian.org http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsuser