Hi, system is - snv_119 (x86) BFU'd 2009-07-22 with NWAM GUI packages 2009-07-23. - Ultra 20 with one connected nge interface. - PCI card added with 4 disconnected hme interfaces
testcase from bug:- http://defect.opensolaris.org/bz/show_bug.cgi?id=10208 ((Tetscase;- 1. with system configured with nwam enabled, with Automatic location active - right click on gnome netstatus applet, select properties - select checkbox "configure network automatically" so that it is disabled. - enter root password. )) ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ Start:- bash-3.2$ svcs -a | grep network/physical disabled 14:41:12 svc:/network/physical:default online 14:41:34 svc:/network/physical:nwam execute testcase 1. Time is 14:47 bash-3.2$ svcs -a | grep network/physical maintenance 14:47:31 svc:/network/physical:default maintenance 14:47:31 svc:/network/physical:nwam more /var/svc/log/network-physical:default.log [ Jul 24 14:41:12 Disabled. ] [ Jul 24 14:47:31 Enabled. ] [ Jul 24 14:47:31 Executing start method ("/lib/svc/method/net-physical"). ] [ Jul 24 14:47:31 Timeout override by svc.startd. Using infinite timeout. ] ifconfig: cannot open link "nge0": I/O error [ Jul 24 14:47:31 Method "start" exited with status 96. ] bash-3.2$ [ Jul 24 14:47:29 Stopping because service disabled. ] [ Jul 24 14:47:29 Executing stop method ("/lib/svc/method/net-nwam stop"). ] Destroyed loc 'Legacy' [ Jul 24 14:47:30 Method "stop" exited with status 0. ] [ Jul 24 14:47:31 Enabled. ] [ Jul 24 14:47:31 Executing start method ("/lib/svc/method/net-nwam start"). ] ERROR: Both svc:/network/physical:default and svc:/network/physical:nwam cannot be enabled at the same time. [ Jul 24 14:47:31 Method "start" exited with status 96. ] # svcadm disable svc:/network/physical:nwam # svcs -a | grep network/physical disabled 14:54:31 svc:/network/physical:nwam maintenance 14:55:52 svc:/network/physical:default svcadm clear svc:/network/physical:default svcadm restart svc:/network/physical:default # svcs -a | grep network/physical disabled 14:54:31 svc:/network/physical:nwam maintenance 15:08:04 svc:/network/physical:default ifconfig -a # ifconfig -a lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1 inet 127.0.0.1 netmask ff000000 lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu 8252 index 1 inet6 ::1/128 # dladm show-phys LINK MEDIA STATE SPEED DUPLEX DEVICE nge0 Ethernet up 100 full nge0 hme0 Ethernet down 0 unknown hme0 hme1 Ethernet down 0 unknown hme1 hme2 Ethernet down 0 unknown hme2 hme3 Ethernet down 0 unknown hme3 # dladm show-link LINK CLASS MTU STATE OVER nge0 phys 1500 up -- hme0 phys 1500 down -- hme1 phys 1500 down -- hme2 phys 1500 down -- hme3 phys 1500 down -- # ifconfig nge0 plumb ifconfig: cannot open link "nge0": I/O error Rebooted the system so that it came back up with bash-3.2# svcs -a | grep network/physical disabled 15:25:07 svc:/network/physical:nwam online 15:25:11 svc:/network/physical:default -------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- After reboot:- using gnome netstatus applet properties, successfully switched to nwam enabled (automatic) disabled 15:27:09 svc:/network/physical:default online 15:27:09 svc:/network/physical:nwam repeated testcase1 from above - using gnome netstatus applet properties, successfully switched to manual disabled 15:29:36 svc:/network/physical:nwam online 15:29:37 svc:/network/physical:default i.e. was not able to recreate bug where both services were put into maintenance. Has anyone else seen similar issues, is there a bug logged ?. Thanks Bob
