Cool, now where's my sawsall? ----- Original Message ----- From: "gus" <[EMAIL PROTECTED]> To: "Fred H. Schlesinger" <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Friday, August 16, 2002 11:22 AM Subject: Re: [nycwireless] dlink ap
> if you open that puppy up (use a very small flat screwdriver on the > single torix screw holding it together) - you'll find an additional > embryonic antenna inside there with its own tiny little coax wire. if > you're careful, you can cut that coax and run it to something like an F > connector and then use simple television coax to connect your AP to > something fun like a pringles antenna. if you do that - you should > probably remove the external antenna. > > > > >Glacier > > > >I've been using the Dlink dwl1000 on my home network. > > > >It works ok. It has been running on my network as an AP for at least a year. > >I've upgraded firmware (requires a windows based computer to load the > >upgrade) The upgrade is free on Dlink's website. and it does allow > >management with html. > > > >I get service through my house, walls and all and onto my front and back > >yards with the little 2 inch dink antenna it comes with. > > > >The antenna does pop off and there is a little dink socket to fit the dink > >plug on the end of the cute little dink antenna aforementioned. > > > >Would take somebody much wiser than I to figure out how to get a plug to fit > >the socket so one could install a hi gain antenna. > > > >Fred > > > >-- > >NYCwireless - http://www.nycwireless.net/ > >Un/Subscribe: http://lists.nycwireless.net/mailman/listinfo/nycwireless/ > >Archives: http://lists.nycwireless.net/pipermail/nycwireless/ > > > > > > > > > > > > > -- NYCwireless - http://www.nycwireless.net/ Un/Subscribe: http://lists.nycwireless.net/mailman/listinfo/nycwireless/ Archives: http://lists.nycwireless.net/pipermail/nycwireless/
