We don't current have support for this.
If it's a single non-table OID, you can probably add it quite easily
using the custom oid feature once the device has been added.
If only it was as simple as just "enabling a mib", things would be much
easier.
Thanks,
adam.
Arnoldo Vidal Bravo via observium wrote on 09/09/2024 13:14:
Hi.
How can I get a NAT's sessions total from Cisco ASR-1002X?
We get SNMP results by snmp v2 and Observium version is 23.8.12.912.
I must enable NAT MIB, but ¿where is an example? NAT MIB can be enable
after add the device?
--
Saluda cordialmente
_______________________________________________
observium mailing list -- [email protected]
To unsubscribe send an email to [email protected]
--
Sent from Postbox
<https://www.postbox-inc.com/?utm_source=email&utm_medium=siglink&utm_campaign=reach>
_______________________________________________
observium mailing list -- [email protected]
To unsubscribe send an email to [email protected]
