Hi, Pretty new here with SAN's and Oracle RAC. I had set up everything but because I wanted to enlarge one of the disks used I removed everything and started over and stumble upon the following:
There is one disk defined on the SAN. This is /dev/sda. I haven't done fdisk yet so I also don't have /dev/sda1 yet. But if I now do the "mounted.ocfs2" command I see the following: # mounted.ocfs2 -d Device FS UUID Label /dev/sda ocfs2 6fe56000-97e6-4ea1-a302-29a8213c6e04 oradb # mounted.ocfs2 -f Device FS Nodes /dev/sda ocfs2 Unknown: Bad magic number in inode This device is also listed when I check it with the ocfs2console. I tried to open it with debug but then I get this: # mount -t debugfs debugfs /debug # echo "fs_locks" | debugfs.ocfs2 /dev/sda >/tmp/fslocks debugfs.ocfs2 1.2.2 Could not open debug state for "6FE5600097E64EA1A30229A8213C6E04". Perhaps that OCFS2 file system is not mounted? If I now use fdisk to create a partition on the device /dev/sda I see the following with the "mounted.ocfs2" command: # mounted.ocfs2 -f Device FS Nodes /dev/sdc ocfs2 Unknown: Bad magic number in inode /dev/sdc1 ocfs2 Not mounted Now the /dev/sda isn't listed anymore in the ocfs2console but the /dev/sda1 is and after actually mounting the /dev/sdc1 I see: # mounted.ocfs2 -f Device FS Nodes /dev/sda ocfs2 Unknown: Bad magic number in inode /dev/sda1 ocfs2 pub.host.com Why do I keep seeing the /dev/sda device? Best Regards, Marcel _______________________________________________ Ocfs2-users mailing list [email protected] http://oss.oracle.com/mailman/listinfo/ocfs2-users
