---
doc/dialup-command-set.txt | 70 ++++++++++++++++++++++---------------------
1 files changed, 36 insertions(+), 34 deletions(-)
diff --git a/doc/dialup-command-set.txt b/doc/dialup-command-set.txt
index a7a1df3..3e40aae 100644
--- a/doc/dialup-command-set.txt
+++ b/doc/dialup-command-set.txt
@@ -1,45 +1,47 @@
-This document specifies the AT command set used in the bluetooth ofono plugins.
+This document specifies the AT command supported in the AT Emulator and atoms.
Bluetooth Dial-up Networking Profile Features Description
=========================================================
-(Ref. document: Dial-up Networking Profile - Bluetooth specification version
1.1 - 22 February 2001)
+(Ref. document: Dial-up Networking Profile - Bluetooth specification
+ version 1.1- 22 February 2001)
-- AT COMMAND SET USED:
+- AT COMMAND set used:
Commands:
- &C Circuit 109 (DCD) Control
- &D Circuit 108 (DTR) Response
- &F Set to Factory Defined Configuration
- +GCAP Request Complete Capabilities List
- +GMI Request Manufacturer Identification
- +GMM Read Model Identification
- +GMR Read Revision Identification
- A Answer Incoming Call
- D Dial
- E Command Echo
- H Hang Up
- L Monitor Speaker Loudness
- M Monitor Speaker Control
- O Return to Online Data Mode
- P Select Pulse Dialling
- Q Result Code Suppression
- S0 Automatic Answer Control
- S10 Automatic Disconnect Delay Control
- S3 Command Line Termination Character
- S4 Response Formatting Character
- S5 Command Line Editing Character (BACKSPACE)
- S6 Blind Dial Delay Control
- S7 Connection Completion Timeout
- S8 Comma Dial Modifier Delay Control
- T Select Tone Dialling
- V DCE Response Format
- X Call Progress Monitoring Control
- Z Reset to Default Configuration
+ &C Circuit 109 (DCD) Control
+ &D Circuit 108 (DTR) Response
+ &F Set to Factory Defined Configuration
+ +GCAP Request Complete Capabilities List
+ +GMI Request Manufacturer Identification
+ +GMM Read Model Identification
+ +GMR Read Revision Identification
+ A Answer Incoming Call
+ D Dial
+ E Command Echo
+ H Hang Up
+ L Monitor Speaker Loudness
+ M Monitor Speaker Control
+ O Return to Online Data Mode
+ P Select Pulse Dialling
+ Q Result Code Suppression
+ S0 Automatic Answer Control
+ S10 Automatic Disconnect Delay Control
+ S3 Command Line Termination Character
+ S4 Response Formatting Character
+ S5 Command Line Editing Character (BACKSPACE)
+ S6 Blind Dial Delay Control
+ S7 Connection Completion Timeout
+ S8 Comma Dial Modifier Delay Control
+ T Select Tone Dialling
+ V DCE Response Format
+ X Call Progress Monitoring Control
+ Z Reset to Default Configuration
Result codes:
OK Acknowledge execution of a command
CONNECT Connection has been established
- RING The DCE has detected an incoming call signal from
network
- NO CARRIER The connection has been terminated, or attempt to
establish
- a connection failed
+ RING The DCE has detected an incoming call signal
+ from network
+ NO CARRIER The connection has been terminated, or attempt to
+ establish a connection failed
ERROR Error
NO DIALTONE No dial-tone detected
BUSY Busy signal detected
--
1.7.1
_______________________________________________
ofono mailing list
[email protected]
http://lists.ofono.org/listinfo/ofono
