Hi Jonas,
On 03/12/2013 08:42 AM, Jonas Bonn wrote:
On 03/12/2013 02:26 PM, Ming Li Wu wrote:
Hello,
I am using Telit HE910 modem, the version of firmware is 12.00.03.
Sometimes, the modem port got stuck after sending AT+CGDCONT=1.
(Such as AT+CGDCONT=1,"IP","internet.tele2.se").
The following was the situation when this problem happened
Aux: > AT+CRSM=192,28621\r
Modem: > AT+CGDCONT=1,"IP","internet.tele2.se"\r
Modem: < AT+CGDCONT=1,"IP","internet.tele2.se"\r
Aux: < \r\n+CME ERROR: 4\r\n
The problem, in short, is that the Telit HE910 does not support sending
any AT command on the Modem port while there is an outstanding command
on the Aux port (this should be true for all Telit modems). Does Ofono
Many M2M setups use the modem from multiple applications (e.g. one app
uses one port for SMS, another for data, another for GPRS). So I'd be
surprised if the Telit firmware had such a limitation. If that is the
case, then the Telit firmware is broken and should be fixed.
support synchronizing these two channels so that they effectively share
a common command queue? If yes, how?
There is no such capability. That would defeat the purpose of having
multiple channels in the first place. About the only thing you can do
is drive everything off of the AUX serial port and only use the Modem
port for entering into PPP mode.
Regards,
-Denis
_______________________________________________
ofono mailing list
[email protected]
http://lists.ofono.org/listinfo/ofono
