Hi Marco,
enable -> pre_sim, sim_inserted -> post_sim, set_online ->
post_online. Generally you do not call set_online before hitting
the post_sim state.
could I don't implement set_online if I don't need it?
That would work, if the modem driver does not implement set_online,
oFono core automatically transitions to Online after CPIN returns 'READY'.
<snip>
I've managing vendor URC for sim detection right now but i have
problems.For instance if I remove it when ofonod is ready the Hilonc
sends an URC to notify sim status changed but after that it reboots
itself(2 sec later)... what i did is to notify the stack that
the SIM
has been removed and modem is powered off . I thought that after
calling
set_powered fnc the stack should have called my driver virtual
disable
function in order to properly close the MUX .. but it's not..
No, if you call ofono_modem_set_powered(modem, FALSE) it assumes
that the modem powered off due to an internally generated event
(e.g. not oFono's doing). The driver has to clean up properly in
this case. The driver disable() method is only called on oFono
initiated power down requests.
mmh ok..so If the modem restarts it's my business to disable and enable
again all the driver' stuff , right?
If the modem resets, then yes you need to call ofono_modem_set_powered
to FALSE. Booting it back up should not be done in the driver, unless
your modem supports so called silent resets. This is where the modem
stack crashes but silently resets itself back to the previous state.
(e.g. no PIN entry is required, initialization is very fast). In that
case use ofono_modem_reset.
<snip>
Glad I could help ;)
Regards,
-Denis
_______________________________________________
ofono mailing list
[email protected]
http://lists.ofono.org/listinfo/ofono
