Hi Denis,

Thanks a lot for the reply!

>> could you please help me with the following issue. I use U-Blox
>> SARA-U270 modem. I'm able to online it and connect to GPRS using both:
>> connman and ofono-tests. The problem occurs when modem loses GSM link.
>> 
>> What I did:
>> 
>>  - Boot board with ofono 1.18
>>  - activate-context & process-context-settings
>>  - ifconfig shows ppp0, everything works
>>  - Disconnect physical GSM antenna, network strength becomes 0 (in
>> list-modems)
> 
> I doubt that this is a good way of testing out-of-coverage conditions. You'd 
> probably need a proper network simulator to do that...
> 

I'm not cellular expert, so probably ask dummy things :-) what can be wrong 
with such test? How it differs from, for example, going underground like metro, 
or tunnel in highway?

>>  - Connect antenna, network strength becomes 40
>> 
>> Problem:
>> 
>>  After these steps, modem doesn't reconnect to GPRS, while
>> list-contexts shows correct settings:
>> 
>> [ /ublox_0 ]
>>     [ /ublox_0/context1 ]
>>         Username = t-mobile
>>         AuthenticationMethod = chap
>>         Protocol = ip
>>         Name = Internet
>>         Settings = { Interface=ppp0 Netmask=255.255.255.255
>> Method=static DomainNameServers=10.74.210.210,10.74.210.211,
>> Address=10.23.6.118 }
>>         IPv6.Settings = { }
>>         Active = 1
>>         AccessPointName = internet.t-mobile
>>         Password = tm
>>         Type = internet
>> 
>> But I don't see ppp0 interface.
> 
> Run oFono with AT command logging enabled as well as debugging enabled.  See 
> HACKING, 'Running from within the source code repository' section for 
> instructions.

Yeah, I've enabled this, but there is no output. The last command was printed 
when I activated context first time, IIRC it was CONNECT.

> 
>> 
>> An attempt to activate-context doesn't do anything, just empty output
>> (with enabled debugging).
>> 
>> Attempt to deactivate-context failed with:
>> 
>> Error deactivating /ublox_0/context1:
>> org.freedesktop.DBus.Error.NoReply: Did not receive a reply. Possible
>> causes include: the remote application did not send a reply, the message
>> bus security policy blocked
> 
> Most likely because your modem's firmware itself has crashed.
> 
>> 
>> The only hard modem reset helps.
>> 
>> Moreover, after antenna disconnect, there is no more cellular service in
>> ConnMan. Only daemon restart helps.
>> 
>> 
>> How should I handle lose GSM network events to keep ppp0 up? Why ofonod
>> hangs with the steps mentioned above?
> 
> oFono itself is not hung, but the underlying modem has.  Remind me, is the 
> SARA a serial based device or USB?

USB, it's connected using ACM Linux driver (ttyACM0-ttyACM6).

Btw: what should be the behavior, when ofono is out from cells coverage? Who 
should deactivate context, ofono or modem?

Alex

> 
> 
> Regards,
> -Denis
> _______________________________________________
> ofono mailing list
> [email protected]
> https://lists.ofono.org/mailman/listinfo/ofono
_______________________________________________
ofono mailing list
[email protected]
https://lists.ofono.org/mailman/listinfo/ofono

Reply via email to