________________________________ From: Sufficool, Stanley [mailto:[email protected]] Sent: Tuesday, September 01, 2009 1:34 PM To: Smith, Stan; ofw_list Subject: RE: Enabling CM for IPoIB
Thanks for the heads up on CM support. I have confirmed that WinOF and SCST SRP Target work fine in a single port I_T configuration. Good news. I have tried the SCST branch with an MT25208 (Lion Cub DDR) dual port PCIe 8x HCA with both ports connected. This causes Windows 2003 SR2 to appear to connect, but then gets errors on the disk reads. Mellanox is the current SRP maintainer. It should probably be noted that the WinOF SRP does not support multipath and both target and inititiator need to be single connected to the fabric. Will make it so. Thank you. -----Original Message----- From: Smith, Stan [mailto:[email protected]] Sent: Tuesday, September 01, 2009 10:56 AM To: Sufficool, Stanley; ofw_list Subject: RE: Enabling CM for IPoIB Connected mode IPoIB did not make it into the WinOF 2.1 release (rc4/5); will be a WinOF 2.2 feature as a NDIS 6.0 driver. BTW, the forest fires have died down to where I can double check your SRP issues. RC4 connected and ran SRP tests to OFED 1.4 SRP target with no problems in my test environment. ________________________________ From: [email protected] [mailto:[email protected]] On Behalf Of Sufficool, Stanley Sent: Tuesday, September 01, 2009 10:41 AM To: ofw_list Subject: [ofw] Enabling CM for IPoIB Did connected mode IPoIB make it into WinOF 2.1-rc4? If so where is this enabled?
_______________________________________________ ofw mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw
