Armin, I was just following up on this questions regarding being able to set the initial size of the pool on DBCP via the OJB.properties.
If this can not be done in the current release, is there a plan to make it available or is there a work around? Could this be accomplished by switching from DBCP to JBOSS? I have never used JBOSS connection pooling with OJB and would like to know if this has been tested and if there are any examples on how to configure OJB with JBOSS? Thank you -Eric -----Original Message----- From: Armin Waibel [mailto:[EMAIL PROTECTED] Sent: Thursday, September 21, 2006 1:30 PM To: OJB Users List Subject: Re: OJB-DBCP initial connection pool setting support Hi Eric, Ferrer, Eric wrote: > Hi, > > > > DBCP supports an initialSize property for initializing connections on > startup, does OJB support this parameter? > A DBCP property 'initialSize' is not supported. Could you point me at the DBCP doc-section describe this property? regards, Armin > > > Thanks > > -Eric > > > > > > Disclaimer: > This email may contain confidential and privileged material for the sole use of the intended recipient(s) and only for those purposes previously or herein authorized by the sender. Any review, use, distribution or disclosure by others, or use by the recipient for unauthorized purposes, is strictly prohibited. If you are not the intended recipient (or authorized to receive for the recipient), please contact the sender by reply email and delete all copies of this message. > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Disclaimer: This email may contain confidential and privileged material for the sole use of the intended recipient(s) and only for those purposes previously or herein authorized by the sender. Any review, use, distribution or disclosure by others, or use by the recipient for unauthorized purposes, is strictly prohibited. If you are not the intended recipient (or authorized to receive for the recipient), please contact the sender by reply email and delete all copies of this message. --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
