Am 11.05.16 um 19:28 schrieb Dale Ghent:
On May 11, 2016, at 12:32 PM, Stephan Budach <[email protected]> wrote:
I will try to get one node free of all services running on it, as I will have
to reboot the system, since I will have to change the ixgbe.conf, haven't I?
This is a RSF-1 host, so this will likely be done over the weekend.
You can use dladm on a live system:
dladm set-linkprop -p flowctrl=no ixgbeN
Where ixgbeN is your ixgbe interfaces (probably ixgbe0 and ixgbe1)
/dale
I have checked all of my ixgbe interfaces and they all report that now
flow controll is in place, as you can see:
root@zfsha01colt:/root# dladm show-linkprop -p flowctrl ixgbe0
LINK PROPERTY PERM VALUE DEFAULT POSSIBLE
ixgbe0 flowctrl rw no no no,tx,rx,bi
root@zfsha01colt:/root# dladm show-linkprop -p flowctrl ixgbe1
LINK PROPERTY PERM VALUE DEFAULT POSSIBLE
ixgbe1 flowctrl rw no no no,tx,rx,bi
root@zfsha01colt:/root# dladm show-linkprop -p flowctrl ixgbe2
LINK PROPERTY PERM VALUE DEFAULT POSSIBLE
ixgbe2 flowctrl rw no no no,tx,rx,bi
root@zfsha01colt:/root# dladm show-linkprop -p flowctrl ixgbe3
LINK PROPERTY PERM VALUE DEFAULT POSSIBLE
ixgbe3 flowctrl rw no no no,tx,rx,bi
I then checked the ports on the Nexus switches and found out, that they
do have outbound-flowcontrol enabled, but that is the case on any of
those Nexus ports, including those, where this issue doesn't exist.
Regards,
Stephan
_______________________________________________
OmniOS-discuss mailing list
[email protected]
http://lists.omniti.com/mailman/listinfo/omnios-discuss
